12VDC / 24VDC LED RGB Signal Amplifiers for Low Voltage RGB 4-Wire or RGBW 5-Wire Color-Changing LED Lighting (typically used for low voltage RGB / RGBW LED Tape Light). Not for use with Single Color LED Lighting. Amplifies the RGB or RGBW signal over long low voltage runs. An RGB or RGBW Signal Amplifier is required for every 16.5 feet of additional 12VDC RGB LED Tape Light, or every 33 feet of additional 24VDC RGB or RGBW LED Tape Light (max run without signal amplifier for 12VDC RGB or RGBW LED Tape Light is 16.5 feet for 12VDC and 33 feet for 24VDC). Alternately, this low voltage RGB or RGBW LED Signal Amplifier can be used for any low voltage 4-wire RGB or 5-wire RGBW LED Lighting that has the same lengths of data / power cables between them using the same lengths mentioned above.
 |
The RGB or RGBW LED amplifiers copy and extend the commands of your master LED color controller. Connecting the amplifier to your LED lights is simple: just match the red, green, blue, white (if RGBW), and black wires of the first section of strip light to the appropriate wires on the terminal block of the Signal Input, match the Signal Output wires on the amplifier to the wires on the second section of strip, then plug the amplifier into the DC Power. See specifications and diagrams below. This lightweight accessory can help you furnish an entire restaurant, club, bar, or event space with led color-changing LED lighting!
|
|
| INFORMATION FOR THIS 12VDC / 24VDC LED RGB AND RGBW SIGNAL AMPLIFIERS BELOW |
 |
FOR: 12VDC or 24VDC RGB or RGBW Color-Changing LED Lighting (typically RGB / RGBW LED Tape Light). Low Voltage RGB or RGBW Controller is not included and required. NOT for use with 12VDC / 24VDC Single Color LED Tape Light.
|
|
MAX POWER LOAD (RGB AMPLIFIER): 12 Amps (144 Watts for 12VDC, 288 Watts for 24VDC). Exceeding this amount on this controller will cause the amplifier (and potentially the 12VDC / 24VDC RGB LED Lighting) to fail and will void all warranties. |
|
|
MAX POWER LOAD (RGBW AMPLIFIER): 24 Amps (288 Watts for 12VDC, 576 Watts for 24VDC). Exceeding this amount on this controller will cause the amplifier (and potentially the 12VDC / 24VDC RGBW LED Lighting) to fail and will void all warranties. |
|
|
DIMENSIONS (RGB AMPLIFIER): 4.2" Length x 2.56" Width x 0.98" Thick |
|
|
DIMENSIONS (RGBW AMPLIFIER): 3.2" Length x 2.52" Width x 0.95" Thick |
|
|
MAX RUN INTERVALS: This RGB or RGBW Signal Amplifier is required to all low voltage RGB runs for every 16.5 feet for 12VDC or 33 feet for 24VDC |
|
|
INSTALLATION: Connects to one end of the LED RGB or RGBW Color-Changing 12VDC or 24VDC RGB / RGBW LED lighting (typically RGB / RGBW Tape Light), then simply connect the other end to lengthen the run, that's it!
|
|
|
WARRANTY: 1 Year Manufacturer's Warranty |
|
|
|
|
|
